鐿宸科技採用完整的新產品開發流程(NPD:New Product Development)來控管設計品質、成本、開發時間、交期來減低量產時可能發生的各種風險。
• EV (Engineering Verification)
• DV (Design Verification)
• MV (Manufacturing Verification)
We define requirements and set the control gate with criteria for each phase. Only project with proven and acceptable quality and data is allowed to move ahead to next design phase. While during MV phase the product/project will be then migrated to NPI (New Product Introduction to mass production) process in which all activities are devoted to ensure product is well ready for following mass production.
ISON employees DFMEA (Design Failure Mode and Effect Analysis) methodology to ensure a product be well designed with robustness and risk-free. The DFX ( Design for various perspectives ) concepts are also utilized throughout the program to earlier address the potential issues in all aspects which are relevant to manufacturing and to initiate prior remedies beforehand, such as in material cost and availability risk in production, readiness of production & test, green & safe environment, after-service effectiveness, etc.
The design works shall follow the defined Design Rules and be reviewed through Check List to avoid any design characteristic be missed and fault recurred. Engineering samples will be made then and tested through series of test items, conditions and criteria according to the designate test plan to justify the design quality as required. The quality and associated designed data and documentation generated in each phase will be reviewed and controlled as mandated evidence to pass through the gate control for each phase.
The design flaws and bugs which are found during the process will be identified, traced and corrected before going for mass production.
ISON is committed to deliver a product that would help our customer be competitive and successful in business.
(Data Analyser / Signal Analyser)
(ESD / Vibration Test)
(Wide-Temperature Chamber / Free Fall)